₹ 16.00
- Overcharge voltage: 4.25±0.05V
- Overcharge release voltage: 4.23±0.05V
- Over-discharge voltage: 2.54±0.1V
- Maximal continuous charging/discharge current: 2A – 5A
₹ 78.00
| Battery | 3 Cell |
| Overcharge detection voltage (V) | 4.25±0.025 |
| Discharge voltage range (V) | 2.3 ~ 3.0±0.05v |
| Continuous charge current (A) | 20 |
| Operational Temperature (°C) | -40 ~ +50 |
| Length (mm) | 59 |
| Width (mm) | 20 |
| Height (mm) | 4 |
| Weight (gm) | 4 |
₹ 85.00
- Three series of lithium battery protection board.
- Automatically cancel protection after protection conditions restore.
- Suitable for lithium battery pack of 11.1V, 12V, 12.6V.
- Quiescent current < 30uA, so power consumption is small.
- With the function of overcharge protection, over discharge protection, short circuit protection, over-current protection.
₹ 15.00
- Type: Quad
- Material: Plastic
- Number of: 14 Pins
- Mounting: Through Hole
₹ 120.00
- Input Voltage(VDC): 4 ~ 40.
- Output Voltage(VDC): 1.3 ~ 37.
- Output Current: 2A Rated, ( 3A maximum with heat sink).
- Switching Frequency: 150 kHz.
- Input reverse polarity protection.
- Built-in output short protection function.
₹ 42.00
| Input voltage | 4-35V |
| Output voltage | 1.5-30V(Adjustable) |
| Output current | Rated current is 2A, maximum 3A(Additional heatsink is required) |
| Switching Frequency | 150KHz |
| Operating temperature | Industrial grade (-40 to +85 ) |
| Conversion efficiency | 92%(highest) |
| Load Regulation | ± 0.5% |
| Voltage Regulation | ± 0.5% |
| Dynamic Response speed | 5% 200uS |
| Dimension | 43 x 20 x 15mm(L*W*H) |
₹ 40.00
- Input Voltage: 4.5V – 28V
- Output Voltage: 0.8V – 20V
- Output Voltage Adjustment: On-board potentiometer
- Output Current: 1.8A (typical), 3.0A (max).
- Ceramic Capacitor Stable
- Internal Soft-Start
- Internally Set Current Limit without a Current Sensing Resistor
₹ 18.00
| Charging accuracy (%) | 1.5 |
| Charging method | Linear |
| Full Charge Voltage (V) | 4.2 |
| Over-Current Protection (A) | 3 |
| Under-Voltage Protection (V) | 2.5 |
| Input Voltage (V) | 4.5-5.5 |
| Rated Power (W) | 4.2 |
| Operating Temperature (°C) | -10 to 85 |
| Length (mm) | 25 |
| Width (mm) | 20 |
| Height (mm) | 6 |
| Weight (gm) | 3 |
₹ 19.00
| Charging accuracy (%) | 1.5 |
| Charging method | Linear |
| Full Charge Voltage (V) | 4.2 |
| Over-Current Protection (A) | 3 |
| Under-Voltage Protection (V) | 2.5 |
| Input Voltage (V) | 4.5-5.5 |
| Rated Power (W) | 4.2 |
| Operating Temperature (°C) | -10 to 85 |
| Length (mm) | 25 |
| Weight (gm) | 20 |
| Height (mm) | 6 |
₹ 355.00
Input Voltage: DC 6-60V
Display Accuracy:0.1V
Control Accuracy:0.1V
Output Type: direct output
Voltage Tolerance:±0.1V
Apply for For:6-60V and MAX 80V battery
Dimension:81*54*18mm
₹ 81.00
- Input voltage range：4～38VDC(Note:input voltage not exceeding 38V)
- Output voltage range：1.25-36VDC adjustable
- Output current: 0-5A
- Output power: 75W
- High efficiency up to 96%
- Built in thermal shutdown function
- Built in current limit function
- Built in output short protection function
- Input reverse polarity protection: None (if required, high current diode in series with the input).
- L x W x H = 5.4*2.3*1.5 CM
₹ 57.00
- Conversion efficiency: <94% (greater the pressure, the lower the efficiency)
- Switching frequency: 400KHz
- Output Ripple: 50mV (the higher the voltage, the greater the current, the greater the ripple)
- Load Regulation: ± 0.5%
- Voltage Regulation: ± 0.5%
- Operating Temperature: -40 ~ 85
₹ 77.70
| Input Voltage (V) | 5 to 80 |
| Operating Voltage (VDC) | 1.25 ~ 20 |
| Max Output Current (mA) | 800 |
| Length (mm) | 44 |
| Width (mm) | 16 |
| Height (mm) | 10 |
| Weight (gm) | 10 |